Find or Sell any Parts for Your Vehicle in USA

Fuel Pump Rv Generator Generac Kohler Onan Yanmar Gas Diesel 4-7 Psi 12v Md7781 on 2040-parts.com

US $36.75
Location:

Jacksonville, Florida, United States

Jacksonville, Florida, United States
Condition:New Brand:BBS Our # MD7781:Manufacturer BBS Manufacturer Part Number:MD7781 RV Generator Fuel Pump:APU Fuel Pump Generac Kohler Onan:RV Generator Fuel Pump UPC:Does not apply

BBS Electronic Fuel Pump
Profesional Grade Plus
Top Quality Best Warranty
100% Factory tested and approved
UL approved And Certified 
for quality, safety and performance
O.E. Fit and form Assurance
Brand new
 Universal Electric Low Pressure Fuel Pump or fuel transfer pump
For Generators RV or APU Gas or Diesel
For Onan, Kohler and Generac Generators
Description
12 Volt 4-7 PSI Flow up to 25-35
GPH Output. 
Pump is self priming

Please note you may need a fuel regulator depending on fuel requirements. Please check before ordering.

Replaces
Onan

149-2620, A029F887, A029F893, A029F891, 149-2331, 
149-2140, 149-2163, 149-2036, 149-2145

Replaces
Kohler
249862, 278490, 277818, GM39462 
and 55-25-559-01-5
Fits

Replaces
Generac
42700 (042700), 74939 (074939), 77663 (077663), 90475 (090475)

Exclusive for our Ebay customers we include a rubber insulator/anti-vibration pad to mount under fuel pump. No other ebay sellers include this insulator.


Solid state reliability: Proven on thousands of original equipment applications, no electrical contacts. No bearings or diaphragms to wear out or fatigue.We use only solid copper winding's most others use inferior aluminum plated copper which won't last long. Ours Lasts four to five times longer than many other electric fuel pumps.

Barbed Fittings, Clamps and fuel filter included. 
Compatible with leaded, unleaded fuels and Diesel

Installation 
Easy Two bolt installation, for best results mount pump close to fuel tank below liquid line,
hook up fuel lines and wire to a fused ignition switched wire and ground black wire and your done. 
Before installing remove any contamination from Fuel tank,
Fuel lines and Carburetor before installing Pump.

Warranty
We give a 30 day money back warranty for unused, not installed pump and a 90 day defective pump exchange, buyer to pay all return shipping
 Disclaimer: seller's liability will not exceed the purchase price of the item   
Please read installation instructions and remove any contamination from Fuel tank, Fuel lines and Carburetor before installing Pump or this can damage the pump and void Warranty.


Included with each pump
  Barbed fittings provided with our pumps are 5/16" OD 
which are for 5/16" id hose. Hose Clamps, 5/16" id short 
hoses and 5/16"od fuel filter included. 
Compatible with leaded and unleaded fuels.

Dimensions
Mounting base 3"x 1 1/2", Mounting holes 2 1/2" center to center,
Pump height 2 1/2", Width inlet to outlet 3" across, 
Barbed fittings hose end 5/16"od x 1/8-27npt.
Please note:
 If you need different size barbed fittings for your application 
they are available at most hardware and auto parts stores. 
You will need to know ID hose size x male 1/8-27npt on the threaded 
side where it screws into the pump 

Jaguar XFR-S (2012) first official pictures

Wed, 28 Nov 2012

Here's Jaguar's M5-killer: the new 2013 XFR-S. By taking an already potent XFR and plumbing in the 542bhp engine from the XKR-S coupe, Jag has created a saloon with XJ220 power. The Jag XFR-S was unveiled today at the 2012 Los Angeles auto show.

Kia Recall: 25,000 UK Kias recalled for faulty brake lights

Sat, 01 Jun 2013

Kia are recalling 25,000 vehicles in the UK Kia’s research and development checks have uncovered a fault in the brake light switch on a whole raft of Kia cars built between 2006 and 2011, with over 25,000 UK-owned Kias being recalled to have a fix. Models affected are previous model Carens, Sedona, Sorento and Sportage and some of the current Sorento and Soul models as well as a few Optimas (actually, just 2 Optimas). This isn’t a huge problem for owners, but Kia has discovered that carbonisation on the brake light switch contacts can make the switch a bit glitchy, with the possibility the brake lights might not come on at all when the brake pedal is pressed or, if they do come on, they may stay on.

Jaguar C-X17 concept (2013) full details on new aluminium chassis

Mon, 09 Sep 2013

Jaguar’s C-X17 crossover concept might have show-stopping looks, but it’s what will lie beneath the production crossover – thought to be called QX – that’s just as intriguing: an all-new aluminium platform, dubbed ‘iQ Al’. It’s a clean-sheet design, with double-wishbone suspension up front, and a multi-link axle at the rear. For more unseen location photos and an in-depth feature, pick up the October issue of CAR magazine, out Wednesday 18 September   Jaguar C-X17 crossover concept: the lowdown on the ‘iQ Al’ aluminium platform ‘It had to be a clean-sheet design to reach our goals,’ says Jaguar vehicle line director Kevin Stride.