1976-86 Jeep Cj 7 Front Cage Kit | Hrew 2" X 1/8" on 2040-parts.com

1976-86 Jeep CJ 7 Front Cage Kit

Our new CJ 7 Front Cage Kit is designed to add onto the stock roll bar that came in the CJ 7 Jeeps and to give you as much head and legroom as possible. We kicked the lower legs under the dash to leave as much room as possible to get in and out of your Jeep. Also in our design instead of just running a straight leg from the floor to the top of the windshield frame we use a compound bend at the dash so that the hoop comes up to the top of the dash straight with the body line and then angles in to follow the angle of the wind shield frame. This gives you  a very clean look to the cage.

Most importantly this cage fits under your hard or soft tops!

Materials Make Us Stronger

All cage kits are made from quality 2″ x 1/8″ (wall) Hot Rolled Electric Welded (HREW) tube. We buy the tube in full 20′ lengths and cut  and notch each piece to precise measurements. Unlike our competition who leaves most of the fab work for you to do, once you have unpacked your kit from us you should have it in your jeep and tacked together in less then 30 min.

This is a weld in kit and should be installed by a certified welder.

Your kit contains

•  1 Front Hoop
• 2  Spreader Bars
• 2  Floor Plates

Note: Main hoop is shipped in two pieces with internal sleeve for reassembly. This saves about $60.00 in shipping cost. We can still ship it to you in one piece if you would like but we must add the additional shipping cost.

***Whole vehicle pictures are shown with the rear bars as well. This item contains only the front cage, as detailed in "Your kit contains" above.