Tuned Port Induction Programming Services

This is a complete Manifold that comes with rebuild Bosch type III 24lbs, Small Cap Distributor, 1227730 ECM and a programmed memcal. If your engine has a bigger cam I will send you a cable to datalog it so I can tune it to perfection. I will recommend a shop for the wiring harness right at $300. The Plenum and runners have been Show Chromed and I sandblasted the Base and squirted it with PPG Topcoat clear. It has all the block off plates along with a Stainless steel bolt kit. This is a 90 or 91 Corvette unit where all the bolts are at 90 degrees. It includes MAP, TPS, MAT, CTS, IAC sensors and has fuel adapters to 6AN. Most importantly is you will have my full support to assure a smooth running engine properly tuned. I built this as if it was for myself. You will need a speed sensor, fuel pump but for the most part it is complete.

Chevy TPI System

This Is What Can be Programmed. VATS (Vehicle Anti Theft System) Enable / Disable EGR (Exhaust Gas Recirculation) Enable / Disable VSS (Vehicle Speed Sensor) Enable / Disable Set Proper Fuel Injector Flow Rate Custom Fuel Mapping For Aggressive Cams Custom Spark Mapping To Maximize Power And Mileage Set Fans For Lower Temperature Thermostats Increase Idle Speed For Aggressive Cam Profiles Bring On Power Enrichment Mode Sooner

Please answer all the questions below that may apply to your specific application. I really care about making your vehicle run at its best, so please take the time to help yourself get it right. You are encouraged to call (775) 530-5892 with any question(s) you may have.

The following questions should be answered to the best of your ability. Some information may not require an answer if your motor is stock. The more information understood the better optimized your programming will be.

#1. Cubic displacement IE: 305, 350, 355, 383, 406, etc.

#2. Transmission type: Automatic, or manual.

#3. Compression ratio and cylinder head type.

#4. Cam specifications: Duration & lift at .050 & Lobe separation angle (LSA)

#5. Vehicle Anti Theft System (VATS): Enable / Disable

#6 Exhaust gas recirculation (EGR): Enable / Disable

#7 Vehicle Speed Sensor (VSS): Enable / Disable

#8 Charcoal Canister Purge (CCP): Enable / Disable

#9 Air Injector Reactor (Smog Pump): Enable / Disable

#10 Knock Sensor: Enable / Disable

#11 Cooling fan(s) settings: 160, 180, or 195. I recommend using at least a 180 thermostat for TPI.

#12 Speed limiter: Default is 255 mph / or specify desired speed.

#13 RPM limiter: Default is 10,000 RPM / I recommend limiting it to 800 rpm over peak horsepower expected.