F13 1080P HD Waterproof Digital Video Camera Recorder Black

Riding a bicycle on the road, you must remember that safety comes first. For the sake of safe riding, you may need a DV. This 1080P H.264 Novatek Program HD Waterproof DV F13 Black has the function of waterproofing. It can be installed on your bicycle easily and firmly. At the same time, it features high-definition screen resolution, so it can monitor and record your riding clearly. Thanks to its high-technology design, it can help you a lot when you are riding a bicycle. This DV will be your good assistant. Do not hesitate any more.

Features

•  Support taking a photograph and charging simultaneously
•  It can record high-definition video in the low illumination
•  High-definition screen resolution
•  Monitor and record your driving clearly
•  High technology and high quality
•  A good assistant for your driving
•  Powered by high-capacity battery  

Specifications

Sensor	5 Mega Pixels CMOS Sensor
Resolution	1920x1080 10FPS ; 1280x720 30FPS ; VGA 30FPS (HD) / 1920x1080 30FPS ; 1280x720 60FPS ; 1280x720 30FPS (FHD)
MicroSDHC	4-64GB
Photo	One 5M,3M,1M Photo Every Two Seconds
Lens	Glass, FOV:120(HD) ; FOV:150(FHD)
SD Memory Card Slot	Micro SD
Video Format	H.264
LED	Green / Red To Confirm Status
Battery LED	Battery Status
USB Interface	USB2.0
Battery	Rechargeable Li-ion 2000MAH Battery
Battery Life	7-8 Hours(HD) ; 3.5 Hours(FHD)
Color	Black
Dimensions	(8.5 x 3.85 x 3.1)cm / (3.35 x 1.52 x 1.22)" (L x W x H)
Weight	4.8 g / 14.39 oz
Waterproof	Yes

Package Includes

• 1 x FHD & HD
• 1 x USB Cable
• 1 x Motor & Bick Mounting
• 1 x Tripod Mount
• 1 x 3M Helmet Mounting
• 1 x Manual

How to Install a Car Camera Recorders in Your Car:

• 1. Disconnect the battery cables from the battery. Check the vehicle′s repair manual to find out what size wrench to use. Leave the disconnected cables a safe distance from the battery posts
• 2. Decide where you want to install the rear-view camera. Most people put them in the plastic bumper so they don′t have to drill into the car′s sheet metal
• 3. Drill a hole for the camera. Check the installation instructions to see what size drill bit to use. Don′t make the hole too large or the camera will fall out
• 4. Place the camera in the hole using the rubber grommet supplied with the camera. Make sure the camera and grommet are tight
• 5. Attach the camera′s power wire to the backup-light power wire on your car. You′ll have to splice the wires together. Use wire cutters to cut the wires, leaving enough excess wire to reconnect. Strip the ends of the wire to expose the bare wire using wire strippers. Splice the wires together using a two-into-one connector. This will give the rear-view camera power when you put the car in reverse
• 6. Route the camera′s output wire to the rear-view monitor and connect the wire to the monitor′s input. For installation of the monitor, see the monitor′s installation instructions
• 7. Reconnect the battery, start the car and put the car in reverse. The rear-view monitor should turn on and give you a view of what′s behind you