Fred Brewer Mopar Heads Alum. 440 And Tunnel Ram To Match on 2040-parts.com

There is a set of Fred brewer heads and Tunnel ram to match for high deck. VERY RARE!!   I got these in a deal on a lot of other mopar parts I bought. the person I got them off of was running these on a 500 cu in motor so I know they are good I took them apart and had a new valve job done didn't need it but just wanted to check them. they got 2.300 intake valves and 1.800 exhaust valves and will fit stock bore blocks. they come with roller valve springs and titanium retainers and spring pressure is set at 275 lbs. at 2.200 installed height. the person I got them off of had send them to muscle motors and had them c and c ported he said muscle motors said they flowed right at 470 on the intake not sure on the exhaust he said it cost him 1100 for the c and c porting. he was running harlem sharp 440-1 rockers on them did not get them in on the deal but I am throwing in a set of indy 440-1 rockers, shafts, and hold downs  with the heads they are 1.5 and the ones he was running where 1.6. the tunnel ram is NICE I talked with fred brewer himself and he told me he sold the tunnel ram for 2000.00 by its self and when he was selling the heads they where about 8000.00 with valves and single 4 intake. the cusbustion chamber cc at 55 cc so you would need a flat top piston that was what he was running. these are big flowing heads and I feel you need bigger cu. in motor to run them on but that is your decision. feel free to call me and I will give you all the info I know....will be shipping UPS cost about 130.00 in the U

           If you need more info or any questions feel free to give me a call Greg 937 765 0911