SUMMER IS HERE, It's time to put this Brand New Rule 500 GPH bilge Pump on your Kawasaki Jet Ski. Replace the Non Working, Bad pump that is in your Jet Ski now with this Brand New 500 GPH one and see the improvements that you been wanting to get the water out of your bilge area.

Brand: Rule Industries

Item Number: 25D,  Manual Pump

Fits: All models of Kawasaki Jet Ski's.

Also Fits: All other Small Boats and Peronal Watercrafts that you want to put this Bilge Pump into. This is a common rule pump that is small and compact that can be installed into any watercraft, jet ski and small boat that just need to get the water out of it that has a 12 volt battery to run the pump.

Voltage: 12 Volt DC

Color: Red/White/Blue.

Description:

500 GPH Bilge Pump Non Automatic The Rule 500 offers many design features while keeping size and cost to a minimum.

Especially popular on smaller crafts like the Jet Ski's.

Rule 500 pumps are unmatched in pumping power and longevity.

Has a 3/4" (19mm) discharge outlet.

12 volts DC.

Only 3 1/2" high by 2 5/16" dia. Pumps to 1/4: deep.

Closed bottom strainer protects inlet.

Pumping Action watercools motor.

Housing is hermetically sealed by Ultrasonic Welding

Stainless steel shaft is sealed by exclusive rule Tellon seal.

High capacity, contiunuous-duty permanent magnet motor.

High efficiency motor gives low 2 amp battery drain.

Pumps 500 gallons per hour at open discharge and 370 gallons per hour at 3 ft head.

This is a Brand New, Rule 500 GPH Bilge Pump, it is a small compact bilge pump that will fit into the Kawasaki Jet ski's.

If you have a Kawasaki Stand-up Jet Ski, this is a pump that should be in every Jet Ski out there. If water get into the hull on the Jet Ski the stock bilge pump does not get the water out fast enough. If you do subs, fountains and tricks with your Jet Ski, you might think about installing one of these in your Jet Ski. Water will come out in minutes instead of 4-5-6 minutes that it takes the manual bilge to remove the water.

These will fit the Special Mounting Brackets made for the Kawasaki Jet Ski's if you have one or already have one installed in your Jet Ski. If you do not have this aftermarket bracket, this pump can also be Epoxy down to the bottom of the hull, back by the bulkhead or bearing mount in your Jet Ski.