Mercury Evinrude Honda Yamaha Outboard Boat Transom Drilling Fixture Template on 2040-parts.com

Outboard engine mounting drill fixture for pre-drilling your boat or pontoon boat transom.

Standard pattern fits most mid to larger size outboards and brands.

Find the center of your boats transom, measuring from the sides parallel to the transom top, measuring from a straight edge placed on the side of the boat, make a mark  at top of transom rear.

Next find the center of the keel, make a mark.

Make a straight line from top mark to bottom mark using a pencil and a straight edge.

Place drill fixture on transom, align marked line to the center of top and bottom center location holes on the fixture plate, then clamp fixture to the transom using a C clamp.

Drill your 4 mounting holes with 1/2" drill bit.

Remove plate, apply sealer around each bolt hole.  Using an overhead hoist or cherry picker crane, hold motor up to line up with holes at the bolt hole height desired.  Apply sealer to the bolts and insert through transom and bolt motor in place.

Note:  sealer not needed on most all pontoon boats.

Click here, to Visit My eBay Store: bmaverick53

Shipping ONLY to your listed Ebay address in the check out system, so if you need it changed, do so there before you pay.

Fast order processing

Buyers are responsible for any international fees for customs, brokers, or tariff fees (if applicable), for shipments to them and any return fees.

Check out my other auctions for quality new and used boat and motor parts and accessories, vintage boat sales brochures, and motor repair videos.