Rear View Camera Truck Crafter Ducato Transit Transportation Master on 2040-parts.com

#name#

With this article maxxcount.de brings a rearview camera on the market that has been developed specifically for use on transporter / van / RV. The common problem: On vehicles with rear doors can not be readily fitted rear view camera. it now uses a conventional configuration camera can indeed align them down, but the rear of many vehicles extends upward slightly round about. A normal reversing camera would capture this curvature and thereby obscure the trailer coupling, the footboard or the bumper.

With the special case of the rear view camera, the camera module itself is set on the buckle out, capturing the entire back wall, bumpers etc. Only this precise maneuvering possible, especially if it is only a few centimeters. The camera module can be set at an angle and can be perfectly adapted to the conditions on your vehicle.

Perfect detail solutions

The 1/4 "Sony CCD sensor allows for optimal image reproduction, the integrated 9 infrared diodes support the vision even in total darkness. The camera eye is enclosed in a spherical head and adjustable therefore comfortable in the detection angle.

Grommet

From the camera itself is a 25cm long cable, this one grommet for the cable gland is already installed.

Perfect design

Unlike normal construction cameras, the case fits well into the overall picture vehicle and in addition it is practical. The supernatant, the camera module can be perfectly adapted to the respective vehicle and see for yourself the towing hook, footboard etc.

To obtain a perfect reproduction even in the dark 9 high-power infrared diodes have been integrated. These allow an illustration of the close range up to 8 meters behind the vehicle. Of course, one was conscious in the development of the special requirements for such a camera, this corresponds to a Sony CCD sensor camera module display fittings of protection class IP68 and is completely water and dust resistant.

reviews:

Guide about the "detection angle" / "Viewpoint" with reversing cameras.

rear view camera with 60 ° detection angle:

To make it as easy as possible to clarify what effect the selected detection angle of the rear view camera has, we have included the presentation of three Different reversing cameras.

The but very small angle of 60 ° does not cover too much in width, but nevertheless illustrates the more "obstacles" in depth. Characterized the camera for monitoring the "blind spot" or for monitoring the immediate surroundings behind the vehicle is not suitable, since not the complete width of the vehicle is detected. The use of this camera could be used as digital rearview mirror for detecting the rear traffic, in agriculture for control of conveyer belts etc..

In contrast, a rear view camera with 170 ° detection angle:

The detection angle of 170 ° is enormous, it is extremely Captures much content in width. This is usually done through various wide-angle lenses. This has the disadvantage that the edges or the edge region is distorted. Content in the depth are shown very small, so you should use the camera only to monitor the immediate close range. For example, in the license plate bar, or even in the trailer operation to the full swiveling be able to detect when maneuvering.

The middle ground, rear view camera with 120 ° detection angle:

From experience to her rear-view cameras have proved best with 120 ° detection angle. You easily capture the entire width of the vehicle, do not produce distortion and still provide a good representation of depth. For example, when mounted on the mobile home or even at the transporter, in the usual height of 2.30 meters, the camera already recorded more than 4 meters in width. aligned Down "barriers" are also in the deep well represented (see figure) Also suitable as a "spy camera" in the bumper of a car,. We carry this the rear view camera STO or STO-IR. For use at the mobile home or the Transportation, we have for example the rear view camera to IR18.