Used Johnson/evinrude 33 Hp Long Shaft Extension Kit on 2040-parts.com

You are looking at a USED Johnson/Evinrude long shaft conversion kit. It was removed from a 1968 Evinrude 33HP that I converted to a short shaft about 5 years ago. This was a fresh water engine than ran & shifted fine. There is some rust/pitting on the upper section of the driveshaft. I have cleaned the shaft & taken pictures best I can. This kit along with some other non-related items were exposed to road salt spray when I moved a few years back & that is what caused the rusting. There is also some wear from the lower bearing just below the water pump. Like I said above, this shaft was removed from a functioning motor.

I realize that there is no shift shaft connector included. Can't remember if this motor had the 5" long shift shaft connector that I remember some models using or if the shift shaft pictured is 5" longer. I did have all the parts taped together until I today when I took the tape off to clean up & photograph. I used parts from a donor lower unit to make the conversion and the fact there is a shift shaft included (and not a connector) suggests this shaft is longer but I can't be certain. You be the judge, but you are buying As-Is, maybe you need a different connector, maybe not.

I am not sure what all the years or HP sizes it will fit. Nor am I sure if can be used to convert an Electric shift model by simply eliminating the shift rod. Again, you are buying As-Is. If you plan to experiment you do it at your own risk.